Installation Instructions
Installation Preparation
warning
•Before working on wiring for any electrical appliance, be sure the power has been turned off at the breaker/fuse box. Place a tag at the disconnect switch indicating that you are working on the circuit.
•Moving this appliance requires two people. Do not attempt to install or lift it alone.
•To prevent personal injury, wear hand protection when moving this appliance.
•Do not allow any material, including the hoses or electrical wiring to be directly behind the dishwasher while pushing it into the cutout opening. Carefully pull the slack out of both hoses and the wiring from outside the cutout during push back to prevent pinching. An electric shock hazard or water damage may result from pinched wires or hoses. Damage due to improper installation is not covered under warranty.
Handle Installation (Model RDW24S)
Install the door handle according to the handle installation instructions.
Door Panel Installation (RDW24I Only)
IMPORTANT:
•The front panel must be installed before proceeding with installation of the dishwasher.
•For proper operation and to prevent cabinet or panel damage, do not allow the panel to obstruct the exhaust vent on the bottom of the door.
•If installing a Dacor glass panel, install it and the handle according to the instructions included with the glass panel kit, then skip to Leveling the Dishwasher on page 11.
•For custom door panels, fabricate the panel according to the included template and attach the handle before proceeding with panel installation.
Custom Door Panel Installation:
1.Install the Dacor trim kit, PN 106925 (if required), on the dishwasher according to the instructions accompanying it.
2.Install the two (2) supplied 3/8” screws on the back of the door panel in the locations shown in the diagram, upper right, leaving 1/8” (3.0 mm) of space between the screw head and the panel.
6 |
|
| 7/16”15 | cm)(39.2 | 3/8” screw, |
|
| included, | |||
10 |
|
|
|
| |
7/8” |
|
|
| 2 places | |
(26. |
|
|
| ||
10 |
|
|
| ||
| cm) | 7/8” |
|
| |
|
| (26. |
|
| |
|
| 6 | cm) |
| |
|
| C |
| ||
|
|
|
|
| |
|
| L |
|
|
|
Door Panel Screw Locations - 3/8” Screws
3.Loosen the door height adjustment screws on each side of the door, near the bottom, and slide the bottom of the door frame down until it stops.
4.Hang the panel on the front of the door by hooking the screws installed in step 2 over the keyholes on the door. Center the panel on the door.
Step 4:
Hang
on keyhole,
2 places
Step 3:
Door height adjustment screw,
both sides
continued...
9