1 | 2 |
Choose starting point | TV system Selection |
Select the "Program" function and then the programme which you want to start manual tuning. Then, the channel number, the frequency, If you don’t know the frequency or channel number then refer to channel searching section. The name and the programme number of this programme are displayed in
the install menu.
If necessary, you can change the TV system :
-Select "system" function.
-Choose between : FRANCE (L/L’), GB (I),
EURO (B/G), E / EURO (D/K) system. Then, the programme displayed on screen is changed to the system chosen.
This procedure can be applied to any individual programme selected.
TUNING
3 | 4 |
Channel searching | Fine Tuning |
MANUAL CHANNEL
-Select "Freq." function.
-Press the remote control
CURSOR RIGHT / LEFT buttons for more than 3 seconds to start (up / down) manual tuning.
-After searching, tuning will stop automatically to the next channel.
(To stop searching press the remote control MENU button)
Note: If you know the channel number or the frequency of the channel you want to search, you can set these channels, entering the data directly into "channel" or "Freq." setting option.
5
Enter station name
-If you are unable to get a good picture or sound because of poor reception, it is possible to fine tune a signal.
-Select channel frequency ("Freq.") function.
-Press and release the remote control
CURSOR RIGHT/LEFT buttons to fine tune a signal.
6
Store programmes in memory
-Select "name" function.
-Use the CURSOR RIGHT/LEFT buttons to select the character (letter) you want to insert.
-To modify this letter press the CURSOR UP/DOWN buttons until the desired letter is displayed and press OK button to confirm.
To store a programme in memory
-Select "store to" function
-Adjust the programme number you want to store and confirm by pressing the remote control "OK" button. (Program number will breifly turn red!)
Remarks: this function can be used also if you want to copy a programme already memorised to another programme number.
16
