Dakota Alert BBT-2500 manual Do Not Open Unit ‘B’, Coding the DCR-2500receiver

ONLY OPEN UNIT ‘A’ IF CHANGING THE ZONE/CHIME IS ABSOLUTELY NECESSARY. It is not recommended to change any settings as the BBA-2500 is factory set to match.

DO NOT OPEN UNIT ‘B’.
				Back of unit		Power Button
Remove the 8 screws on
the back of unit ‘A’ (Fig-
ure 5-1). Gently lift the
solar	panel	to	expose		Screws
the	transmitter		board			Screws
(Figure 5-2). Locate the
10 dip switches on the
red	block.	The first				Figure 5-1
eight dip switches are
for the frequency set-
ting (256 combinations). Set switches
1-8 to match the eight switches in the
receiver. Switches 9 and 10 are for the
zone/channel settings on the trans-
mitter. The four zones are listed in the
table below.

				Transmitter module
					Change tone
Switch	Switch	Channel	Tune
9	10
On	On	1	Classical	Figure 5-2
Off	On	2	Westminster
On	Off	3	Ding Dong
Off	Off	4	Whistle

Change frequency

Coding the DCR-2500 receiver:

Open the receiver case by inserting a small screwdriver into one of the pry notches on the side of the case (refer to receiver manual). Gently lift off the front cover. Locate the eight dip switches on the DCR-2500 and make sure they are set identically to dip switches 1-8 on the BBT-2500.

Note: If more than one transmitter is used with the receiver, the first eight dip switches of all transmitters must match the eight dip switches of the receiver.

Note: Whenever a change is made to the time jumper or the dip switches, the receiver must be turned OFF and then back ON to operate properly.

6