Dakota Alert ad-01 slave owner manual Installation, Set Up

Installation

Tools needed: Small Phillips Screwdriver; Large Phillips Screwdriver; Small Standard Screwdriver.

Set Up:

1.Install the back-up battery (included) into the auto dialer. Use a small Phillips screwdriver to remove screw above battery cover (Figure 1-2). Remove cover by sliding downwards. Plug in battery pack making sure not to force onto pins incorrectly. Put battery pack in space provided, close battery cover, and replace the screw.

Figure 1

1 4 5 3 2

3. Connect the power supply to the dialer by inserting

the red wire into the 12V+ terminal and the black wire into the OV terminal (Figure 2). Using a small standard screwdriver, turn the screws on the terminal to secure the wires.

4.The dialer can support two alarm trigger inputs (normally open) plus a tamper alarm output (normally closed).

4

AD-01 Slave Manual.indd 4

10/15/2009 10:20:44 AM