Dakota Alert dakota alert wireless alarms and security equipment, ad-01 slave owner manual

TAMPER ALARM: The tamper alarm is alarmed	Figure 2 (from Figure 1-1)
when the button on the back of the dialer		TAMP	TR2		TR1		OV	12V+
(Figure 1-3) is depressed. If the tamper output is
to be used it is important to be sure the button is
depressed when the unit is mounted. The tamper
terminals can be connected to any existing
security system or alarm that accepts a normally				2	Trig	1		12V
closed input trigger. If the tamper output is not			Trig
connected to any system, the jumper wire must
remain between these terminals.
TR1/TR2: Triggers 1 and 2 support sensors with
normally open outputs. For Trigger 1, the sensor	OV = Universal Ground
wires would be connected to the TR1 terminal
and the OV terminal (Figure 2). For Trigger 2,

the sensor wires would be connected to the TR2 terminal and the OV terminal. (Note: Since these terminals are simply “switches” there is no positive or negative. The wires can be hooked up either way.)

5.Plug the supplied phone cord into the “LINE” jack (Figure 1-4) and then into your home phone jack. If you wish to connect a phone at the dialer location, you can connect the phone to the “PHONE” jack (Figure 1-5) on the dialer.

6.Continue on to the Advanced Operations to program your dialer or refer to the “AD-01 Quick Reference Programming” on page 14.

5

AD-01 Slave Manual.indd 5

10/15/2009 10:20:44 AM