Dakota Digital Gauge Installation
This sheet covers the installation of the Dakota Digital gauge kit into the original clusters.
1.Remove the clusters from the vehicle. The procedure for the speedometer and tachometer clusters are the same, but only one side is shown in the photos.
2.Remove the three screws holding the bezel on to the gauge can. Two are indicated by the upper arrows in the photo at right; one is on the bottom side of the can and cannot be seen here. After the bezel is set aside, remove the two screws near the center of the can to remove the original gauge. On the speedometer can (shown) you will also need to remove the trip meter reset cable.
3.Use the provided flexible grommet material on the edge of the mechanical cable openings on the original gauge cans to protect the ribbon cables. A few dabs of silicone will help hold it in place. Pass the ribbon cables through the lined cable openings until the gauge assemblies sit into the cans and the cables are not being pinched.
4.Use four of the supplied
5.
