Danby dim1524w manual Self-Clean Mode, Operating Instructions, Add water & vinegar, Stage

Operating Instructions

Self-Clean Mode

1Add water & vinegar (1:1)

2With the power off, simultaneously depress the increase & decrease arrows twice.

3Drain after program is complete.

4 Add fresh water to fill line.

5 Repeat Step 2

6 Drain after program is complete.

The self-clean mode should be put into operation before you use your ice maker for the first time and/or if there has been a long period without use.

Stage 1

•Add equal parts of water and vinegar (1:1) to the ice maker’s reservoir.

•With the power off, press the increase and decrease arrows simultaneously two times to activate the self-clean mode. Please note, the self clean mode with automatically initiate approximately 10 seconds after the last button depression.

•During the self clean mode, the upper ice bucket is filled and dumped multiple times and the pump will remain in contin- uous operation as it feeds water to the bucket and evapo- rator coils. This cycle contin- ues for approximately five-and- a-half minutes.

Upon completion, the unit auto- matically powers down and is now ready for stage 2.

Stage 2

•Drain the cleaning solution from the internal reservoir by removing the rear drain cap and plug (see pg. 9).

•Add fresh water to the ‘Fill line’ in the internal reservoir.

•With the power off, press the increase and decrease arrows simultaneously two times to activate the self clean mode- which will now act as a rinse.

Upon completion of this final stage of the self clean process, the unit automatically powers down once again. Proceed to drain the water from the inter- nal reservoir and leave the lid on the ice maker open to allow it to air dry.

8