UNIT PARTS IDENTIFIED
Control Panel
Air outlet |
|
|
|
| Air intake | ||
|
| ||
|
| (evaporator) | |
|
|
| |
|
|
|
|
Signal | Handle |
| |
Hole |
| ||
receptor |
| ||
|
|
| |
|
|
| |
Air intake |
| Air outlet |
hose |
| hose |
|
|
|
|
|
|
Castor
Water outlet drain | Power supply cord |
IMPORTANT SAFETY INFORMATION
READ ALL SAFETY INFORMATION BEFORE USING
ELECTRICAL
SPECIFICATIONS
1)All wiring must comply with local and national electrical codes and be installed by a qualified electrician. If you have any questions regarding the following instructions, contact a qualified electrician.
2)Check available power supply and resolve any wiring problems BEFORE installation and operation of this unit.
3)This appliance draws 10.8 nameplate amps under Cooling Mode and may be used in any properly wired, general purpose 15 amp household grounded receptacle.
4)For your safety and protection, this unit is grounded through the power cord plug when plugged into a matching wall outlet. If you are not sure whether the wall outlets in your home are properly grounded, please consult a qualified electrician. DO NOT USE PLUG ADAPTERS OR EXTENSION CORDS WITH THIS UNIT. If it is necessary to use an extension cord with this unit, use an approved “air conditioner” extension cord only (available at most local hardware stores).
5)The manufacturers nameplate is located on the rear panel of the unit, and contains electrical and other technical data specific to this unit.
6)To avoid the possibility of personal injury, always disconnect the power supply to the unit before installing and/or servicing.
TABLE 1
Suggested Individual Branch Circuit
Nameplate Amps | *AWG Wire Size |
10.8 | 16 |
AWG- American Wire Gauge
*Based on copper wire at 105°C temperature rating.
TABLE 2
Receptacle and Fuse Types
Rated Volts | 125 |
|
| |||
|
|
|
|
|
|
|
Amps | 15 |
|
|
| ||
|
|
|
|
|
|
|
Wall Outlet |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fuse Size | 15 |
|
|
Time Delay Fuse | Plug Type |
(or Circuit Breaker) |
|
CAUTION: Do not leave this unit unattended in a space where people or animals cannot react to a failed unit are located. A failed unit can cause extreme overheating or death in such an enclosed, unattended space.
3
