C-BOX 150
2
2.5 OPERATING MODES
With the C-BOX 150, the following operating modes are possible:
Normal Operation: At power on, the C-BOX 150 tries to connect to the scanner.
Once the connection procedure is completed the C-BOX 150 verifies if an Automatic
SEND command must be executed. While executing the command, the serial
Auxiliary interface is not available for the user. After the command completion, the
warning LED will turn OFF and the Aux interface will become free for communication.
After the initialization procedure, in the Normal operating mode the scanner reads
barcodes and communicates with the host.
Also in this mode, through the C-BOX 150 internal buttons it is possible to
communicate with the scanner to perform one of the three GET/TEST/SEND
Functions (see paragraph 2.5.1).
Configuration (CFG): When the CFG switch is in CFG position (left) it is possible to
configure the C-BOX 150 parameters through WinHost.
2.5.1 GET/TEST/SEND Functions
The C-BOX 150 has three internal function buttons which are available in the Normal
operating mode.
C-BOX 150
GET TEST SEND
Figure 15 – Internal Function Buttons
The procedure to enable the GET/TEST/SEND function is the following:
1. Press both the left and right buttons at the same time for at least one second;
the warning LED will turn ON.
16