Datalogic Scanning C-BOX 150

INSTALLATION 2

1 blinking/sec: a requested operation has been terminated

abnormally.

2 blinking/sec: a wrong operation has been requested (for

example the configuration in memory is not compatible

with the connected scanner).

STATUS (SL) (yellow) indicates the status of the non-volatile memory

support.

Off: the memory is empty (no configuration on board).

1 blinking/sec: the memory is not empty (a Get scanner

configuration service has been executed)*.

2 blinking/sec: the memory is not empty (a Get Scanner

Configuration service has been executed); however the

saved configuration is not compatible with the current

scanner one.

TRANSMISSION (TX) (green) indicates there is communication between the C-

BOX 150 and the scanner. This LED blinks during the

connection procedure.

* This is the typical state after correct system installation.

Contents

Main Page CONTENTS SAFETY PRECAUTIONS POWER SUPPLY CE COMPLIANCE WEEE COMPLIANCE v GENERAL VIEW C-BOX 150 Compression connectors Cover screws (4) C-BOX 150 Power on switch 8 Scanner selection switch 2 GUIDE TO INSTALLATION 1 INTRODUCTION 1.1 PRODUCT DESCRIPTION 1.2 C-BOX 150 COMPATIBLE DEVICES 2 INSTALLATION 2.1 PACKAGE CONTENTS 2.2 OPENING THE DEVICE 2.3 MECHANICAL INSTALLATION Page 2.4 ELECTRICAL CONNECTIONS AND HARDWARE SETUP 2.4.1 Power Supply C-BOX USER INTERFACE 2.4.2 System Wiring Page Page 2.4.3 Scanner Chassis Grounding Jumper Settings 2.4.4 Scanner Selection 2.4.5 RS485 Bus Termination 2.4.6 Powering C-BOX 150 From A Scanner 2.4.7 OM4000 Jumper Settings 2.4.8 Configuration Switch And 9-Pin Internal Connector Page 2.5 OPERATING MODES 2.5.1 GET/TEST/SEND Functions Page 2.5.2 LED Indicators Page 2.6 TYPICAL LAYOUTS 2.6.1 1000, 2000A/N, 4000 Family Scanners 2.6.2 2000N Family Scanners 2.6.3 6000, 8000 Family Scanners 2.7 SCANNER REPLACEMENT 3 TECHNICAL FEATURES