Datalogic Scanning C-BOX 300, C-BOX 310 2.9.2 Matrix Reader Configuration Using VisiSet , 2.9.3 Completing C-Box 3x0 Configuration for Matrix-1000 Readers

INSTALLATION 2

2.9.2 Matrix Reader Configuration Using VisiSet™

After performing C-Box 3x0 configuration as described in the previous paragraph, the

Matrix reader can be configured through the C-Box 3x0 9-pin internal connector

connected to the PC using the VisiSet™ configuration program:

1. Run the VisiSet™ configuration tool and select Connect to communicate with

the Matrix reader;

2. Configure the reader and save the configuration;

3. Select Disconnect and close the VisiSet™ configuration tool;

4. For Matrix-2000™ the configuration is complete, close the C-BOX 3x0.

For Matrix-1000™ follow the instructions in the following paragraph to complete

the configuration.

2.9.3 Completing C-Box 3x0 Configuration for Matrix-1000™ Readers

CAUTION

When connected to a C-BOX 3x0/4x0, Matrix-1000™ can only

communicate through its Auxiliary Interface.

Once Matrix-1000™ has been configured through VisiSet™ as described in the

previous paragraph, to complete the configuration procedure the C-Box 3x0 must be

reconfigured to accept data from the Matrix-1000™ reader through its Auxiliary

RS232 interface (the only RS232 interface available).

1. Move the C-Box 3x0 Configuration Switch from the Normal Operation to the

CFG position;

2. Connect the 9-pin internal port of the C-BOX 3X0 to the PC (using a crossover

cable) and run the Winhost™ configuration tool;

3. Select the Connect option to open communications with the C-BOX 3X0 and

wait until the correct communication speed has been determined;

4. From the SCANNER INTERFACE menu, set Data Source: Aux Interface and

save the configuration to the C-Box 3x0 (refer to Figure 18);

5. Return the Configuration Switch to the Normal Operation position;