Datalogic Scanning Modem - page 16

STARModem™
8
UK/US
INTERFACE SELECTION
Select the desired interface string for your application, then set the correct hardware
jumper position (see "STARModem™ Initial Setup" for jumper setting).
Among the following interface selection strings, send only the string that suits
your application:
Jumper
Position
RS232 Interface $+CP0$-CR 1
Pen Emulation Interface $+CP6$-CR 2
Wedge Interface
IBM AT or PS/2 PCs $+CP500$-CR 2
IBM XT $+CP503$-CR 2
PC Notebook $+CP505$-CR 2
IBM SURE1 $+CP506$-CR 2
IBM Terminal 3153 $+CP504$-CR 2
IBM Terminals 31xx, 32xx, 34xx, 3 7xx
To select the interface for these IBM Terminals, send the correct KEY
TRANSMISSION string. Select the KEYBOARD TYPE if necessary (default =
advanced keyboard).
Make-only keyboard
$+CP502$-CR 2
Make-break keyboard
$+CP501$-CR 2
Advanced keyboard
$+FK1$-CR 2
Typewriter keyboard
$+FK0$-CR 2
ALT MODE
The ALT-mode selection allows barcodes sent to the PC to be interpreted correctly
independently from the Keyboard Nationality used. You do not need to make a
Keyboard Nationality selection.
(default = Num Lock Unchanged).
Make sure the Num Lock key on your keyboard is ON.
IBM AT- ALT mode $+CP507$-CR 2
PC Notebook - ALT mode $+CP508$-CR 2
Wyse Terminal - ANSI Keyboard $+CP509$-CR 2
Wyse Terminal - PC Keyboard $+CP510$-CR 2
Wyse Terminal - ASCII Keyboard $+CP511$-CR 2
Wyse Terminal - VT2200 style Keyboard $+CP514$-CR 2
APPLE ADB Bus $+CP513$-CR 2
Digital Term inal VT2xx/3xx/4 xx $+CP512$-CR 1