Datalogic Scanning Modem - page 19

DATALOGIC
11
UK/US
SET RADIO ADDRESSES
Follow the procedure below to set the STARModem™ radio address and prepare it
to receive and transmit data to all devices included in the range from the First to the
Last STAR-System™ destination device.
1. Enter Configuration $+
2. Set STAR

Modem™ Radio Address
xxxx = four digit s for the STARModem™ address (from
0000 to 1999). This address must be unique. MA1RCxxxx
3.
First STAR-System™ Destination Device Address
xxxx = four digit s for t he Dest inati on Devi ce address (from
0000 to 1999). MSxxxx
4.
Last STAR-System™ Destination Device Address
xxxx = four digit s for t he Dest inati on Devi ce address (from
0000 to 1999).
If transmitting to one Destination device only, this selection
is not required.
MTxxxx
5. Set RF Baud Rate (not for USA model)
x = 0 defines 9600 baud
1 defines 19200 baud MFx
6. Exit and Save Configuration $-CR
When defining a range of destination device addresses, STARModem™ activates
roaming towards all the devices included within this range.
No interface selection is required, since all STAR-System™ transactions occur via
serial interface.