Datamax datamax-o'neil manual Ribbon Shield Screws Lllllll llll lll llllllllll lllll

E)Wrap the Ribbon in a clockwise direction around the Take-Up Hub. Press the TEST Button on the Front Panel then use the UP / DOWN Buttons to select the RIBBON TEST LABEL. Select a small quantity of labels and press the ENTER Key. As the labels are output, observe the flow of the Ribbon from the Printhead Assembly to the Take-Up Hub. Proceed according to your observations:

				Ribbon
				Take-Up
				Hub
				Printhead
				Assembly
	llllllllllllllllllllllllll
	llllllllllllllllllllllllll
		llllllllllllllllllllllllll
	llllllllllllllllllllllllll
Front
Panel			observe for flow

If the ribbon flow is smooth, press the CANCEL Key, and then proceed to F; or,

If the ribbon flow is rippling or if bagging is present, slightly loosen both Ribbon Shield Screws and then move the Ribbon Shield ‘in’ or ‘out’ to smooth the flow of the ribbon. Afterward, carefully tighten the Ribbon Shield Screws. Print several more labels to verify your adjustment. When finished, press the CANCEL Key to stop printing.

llllllllllllllllllllllllll

llllllllllllllllllllllllll

llllllllllllllllllllllllll

llllllllllllllllllllllllll

Ribbon Shield

Screws

lllllll llll lll llllllllll lllll

lllllll llll lll llllllllll lllll

Ribbon

Shield

6