
Unpacking and Installation Instructions
Unpacking and Examining Your Oven
Remove: all packing materials from inside the oven cavity; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right cavity wall. Read enclosures and SAVE
the Operation Manual.
Check the oven for any
damage, such as mis-
aligned or bent door,
damaged door seals and sealing surfaces, broken or loose door hinges and
latches and dents inside
the cavity or on the door.
If there is any damage, do not operate the oven and contact your dealer or DCS AUTHORIZED
SERVICER.
Choosing a Location for Your Oven on the counter
You will use the oven frequently so plan its location for ease of use. It’s wise, if possible, to have counter space on at least one side of the oven. Allow at least 2 inches on the sides, top and at the rear of the oven for air circulation.
OVER OVEN INSTALLATION
| TOP OF |
| MICROWAVE |
| SHELF |
MICROWAVE | 1" |
CUTOUT | (25MM) |
| WALL |
| OVEN CUTOUT |
401/4"
(1022MM)
OVER WARMING OVEN INSTALLATION
Choosing a Location for Your Oven if built-in
Your oven can be built into a cabinet or wall by itself or above any DCS wall oven listed below using DCS’s
TRIM KIT FRAME
ASSEMBLE
MICROWAVE
CUTOUT
RECOMMENDED HEIGHT 36"
(914MM)
OVEN FRONT
2"
(51MM)
WARMING
OVEN CUTOUT
The applicable wall ovens and warming ovens are as follows:
OVENS - WO 127, WO 130
WARMING OVENS - WD 27, WD 30
Do not built-in above any other gas or electric wall oven.
See
The opening in the wall or cabinet must be within the following dimensions:
A | HEIGHT | : 16 3/4" to 17" |
B | WIDTH | : 24 3/8" to 24 11/16" |
C | DEPTH | : minimum 20" |
4
2.DCS MO24SS / B268 | 4 | 10/31/2001, 4:25 PM |