DCS CT-365SS, T-365BK Power Requirements, Recommended Grounding Method, Third Ground Prong

INSTALLATION INSTRUCTIONS

GAS CONNECTION FOR CT-365 GAS CONNECTION FOR CT-304

4 FOOT POWER CORD

ELECTRIC SUPPLY

COUNTER TOP

REGULATOR

Installer supplied shut-off valve must be easily accessible inside cabinetry

GAS SUPPLY

		COUNTER TOP
		REGULATOR
	900 Elbow	Installer supplied
		shut-off valve must
	supplied*	be easily accessible
	(CT-304	inside cabinetry
4 FOOT POWER CORD	only)

GAS SUPPLY

ELECTRIC SUPPLY

• Required when unit is installed over Wall Oven

Power Requirements:

120 VAC, 60 Hz., single phase.

CT-304/CT-365: 0.10 Amp. Max.

(Use 15 Amp. circuit minimum)

Always disconnect the electric supply cord from the wall outlet or turn off the electricity at the service disconnect before servicing this appliance.

Observe all governing codes and ordinances when grounding, in the absence of which, observe National Electrical Code ANSI/NFPA No. 70-1990.

Recommended Grounding Method:

This appliance is factory equipped with a power supply cord with a three-prong grounding plug (with polarized parallel blades). It must be plugged into a mating grounding-type receptacle, connected to a correctly polarized 120 Volt circuit. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the installer or user to have the existing receptacle changed to a properly grounded and polarized receptacle in accordance with all applicable local codes and ordinances by a qualified electrician. In the absence of local codes and ordinances, the receptacle replacement shall be in accordance with the National Electrical Code. THE THIRD GROUND PRONG SHOULD NOT, UNDER ANY CIRCUMSTANCES, BE CUT OR REMOVED. The electrical supply must be a 120 volt, 60 Hz single phase, 15 AMP circuit. The power receptacle must be a NEMA 5-15R device to accept the three prong plug supplied with the unit.

THIRD GROUND PRONG

10