DCS WD-30-BL manual Mounting Installation, Step, Installation Instructions

Installation Instructions

MOUNTING INSTALLATION

The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and the anti-tip mounting clips. A 120 volt AC outlet should be located no further than

36 inches from the back center of the Warming Drawer. Illustrations suggest one possible bottom sup- port, but the consumer is not limited to this idea for mounting configuration.

STEP 1

The bottom rear section of the cabinet should be made of solid plywood or 2x4 and needs to be installed to hold the anti-tip mounting clips and support the weight of Warming Drawer, which is 90 lbs.

STEP 2

Use the screws provided to attach the mounting clips which must be installed for anti-tip safety to the bottom support at the back. See placement dimensions in figure below.

STEP 3

The Warming Drawer has slots on the back side where it will slide onto the anti-tip mounting clips. Plug power cord into AC outlet. See page 7.

STEP 4

Screw the front face screw into the center hole of the front face of the warming drawer to finish the installation. See page 7.

NOTE: Bottom support made of plywood or other solid wood construction capable of supporting the weight of the warming drawer.

FIG.04 STEPS 1 & 2

21 5/16"

Slide drawer

on to Anti-Tip mounting clips

mounting clips

6