Definitive Technology IWSUB1010 owner manual

Figure 1 Figure 2

2.Make certain to incorporate at least 11/4" of space above and below the area within the inner wall space to make room for the IWSub’s locking arms.

3.With these measurement requirements in mind, place the template against the inside edge of one of the studs. (Do not “center” the template if your studs are wider than 141/2"–151/2".) Use a level to make certain the template is straight and plumb. The outside edge of the template will

be your exact cutout size. [Figure 1]

4.Carefully cut the hole with the appropriate cutting tool for your wall mater- ial. Start the hole by drilling a hole on the inside of the template line (with the drill bit touching the line). Use this hole to insert your saw or knife and begin cutting. [Figure 2]

Figure 3 Figure 4

5.Before installing the speaker in the hole, apply the four long strips of gasket material to the speaker: two pieces on each side of the speaker that will come into contact with the studs. [Figure 3] Use the three shorter strips of gasket material to pad the rear of the speaker against the back of the exposed wall. [Figure 4]

5