Solid plates
Red dot plates
• Plates featuring a red dot in the centre are high speed, wattage plates for increased
• For your safety these plates are fitted with thermal Should a plate be accidentally switched on and left the limiter will reduce the power output of the plate and mise the risk of overheating and the possibility of
Caring for Solid Plates
•Before using the plates for the first time, switch them on for about 4 minutes at the est setting. This allows the factory applied protective coating to burn
•To prevent blotchy discolouration and corrosion, moisture from spatters and should be cleaned off
•To clean the plates, wipe them with a damp cloth or nylon pad. A little liquid may be used. Do not use metal scourers or sharp metal objects to clean the
•After cleaning, dry the plates by switching them on for a short
•To prevent rust, periodically apply some, sewing machine oil or electrical hotplate ish - available from Defy Service Centres. Extra attention is required in areas of humidity or in close proximity to the
NOTE: THE WARRANTY DOES NOT COVER THE REPLACEMENT OR REPAIR OF RUSTED OR CORRODED PLATES.
Recommendations
•Use only pots with a solid level base. An uneven base can prolong cooking times waste energy.
•Use pots with a base diameter slightly larger than the plate. This will ensure even distribution and prevent spillage from dripping onto and staining the hot
•Always cover the pot with a lid. This will conserve energy and minimise
•Thermal shock could damage the plates. Do not put cold pots on very hot
•Plate controls
•Select the heat level by turning the relevant plate control knob to the required
•The higher the number selected, the hotter the temperature of the plate will
•The plate indicator light will glow when a plate is switched
9
