X6741bk0.book Page 10 Wednesday, September 22, 2004 1:55 PM
w w w . d e l l . c o m s u p p o r t . d e l l . c o m
Attaching and Removing the Computer Stand
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTE: Place your computer on a soft surface to prevent scratching the top cover.
Your computer can be used in either a vertical or horizontal position.
To use the computer in a vertical position, you must attach the computer stand:
1Place the computer on its right side so that the drive bays are at the bottom and fit the stand onto what was the left side of the computer:
a Position the stand as shown in the following figure by aligning the large round hole in the stand with the securing button on the side of the cover.
b Align the captive screw in the stand with the screw hole in the cover, and tighten the thumbscrew.
2Rotate the computer so that the stand is at the bottom and the drives are at the top.
10
