4-16 Dell PowerEdge 2100/180 and 2100/200 Systems Service Manual
Microprocessor/Heat Sink Assembly
Figure 4-15. Microprocessor Securing Clip Removal
To remove the microprocessor/heat sink assembly, follow these steps:
1. Remove the system board assembly.
2. Lay the system board assembly on a flat surface.
3. Remove the microprocessor securing clip from the microprocessor/heat
sink assembly.
Press down on the folded part of the clip with a small screwdriver to release
the clip.
4. Push outward and then upward on the release lever to rotate the lever
to its fully vertical position.
5. Lift the microprocessor/heat sink assembly out of its socket (see
Figure 4-16).
WARNING: The microprocessor can get extremely hot during sys-
tem operations. Be sure it has had sufficient time to cool before
touching it.
microprocessor
securing clip hooks
over tabs on socket
(front and back)
microprocessor
heat sink
socket release
lever
microprocessor
socket