Cisco Systems AIRPWRINJ15002 manual Go to the Mounting Bracket Assembly on a Pole section on

Chapter 2 Installing the Access Point

Mounting the Access Point

Step 1 Position the strap brackets on the pole clamp bracket for the pole diameter you are using and secure each strap bracket with two M8 x16 bolts (with lock washers) (see Figure 2-9). Tighten the bolts to 13 to 15 ft lbs (17.6 to 20.3 Nm).

Figure 2-9 Assembled Pole Clamp Bracket and Strap Brackets

1

2

M8 x1.25x16 bolts (with lock washers)	3	Strap bracket (shown positioned for 11
		to 16 inch diameter pole)
Pole clamp bracket

Step 2 Screw the M8 nut onto the pole clamp bracket support bolt, and tighten just enough to prevent the bolt from falling off.

Step 3 Go to the “Mounting Bracket Assembly on a Pole” section on page 2-20.

	Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01		2-19