Cisco Systems AIRPWRINJ15002, AIRCAP1552EAK9RF Unless the metal bands are cut or disassembled

Chapter 2 Installing the Access Point

Mounting the Access Point

Figure 2-11 Metal Strap Open Space for 3.5 inch (8.9 cm) and Smaller Poles

1

Metal strap open space

	Caution	Do not place the metal straps in the large open area between the pole clamp bracket and the strap brackets
		because this does not properly secure the access point.
	Step 4	Position the pole clamp bracket on the pole as needed before tightening the metal bands.
		Note	When the metal bands are tightened to the full tension, the pole clamp bracket cannot be adjusted
			unless the metal bands are cut or disassembled.
	Step 5	Tighten the metal bands using the banding strap tool (BAND IT) (Cisco AIR-BAND-INST-TL=) by
		following the operating instructions in the box with the tool. Ensure that the metal bands are as tight as
		possible.
	Step 6	Place the mounting bracket onto the pole clamp bracket support bolt (see Figure 2-12).
	Step 7	For vertical poles, position the mounting bracket as shown in Figure 2-12. For horizontal streetlight
		poles, rotate the mounting bracket 90o from the position shown in Figure 2-12.
	Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-22			OL-24247-01