Cisco Systems AIRPWRINJ15002, AIRCAP1552EAK9RF manual Opening the Access Point Hinged Cover, 2-13

Chapter 2 Installing the Access Point

Installation Guidelines

Opening the Access Point Hinged Cover

You need to open the access point hinged cover when you are installing fiber-optic SFP module and fiber cable take-up reels.

To open the access point hinged cover, follow these steps:

Step 1 Use 0.5-in (13-mm) box-end wrench or socket set to unscrew and remove the four bolts on the front cover of the unit. Only unscrew the hinge bolts about 2 turns until they are easily turned by hand, do not remove the bolts on the hinge (Figure 2-5).

Step 2 The cover is hinged on the bottom. Carefully open the cover and remove the cover.

Note If the cover does not open easily, carefully loosen the hinge bolts again.

Figure 2-5 Access Point Front View of Hinged Cover

11

1 1

255250

22

1

M8 x32 bolts

2

Cover hinge M8 x32 bolts

Closing the Access Point Hinged Cover

To close the access point cover, follow these steps:

Step 1 When closing the access point cover, be careful not to pinch internal wires.

Step 2 Carefully position the cover flush with all sides of the access point, then slowly hand-tighten each bolt.

	Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01		2-13