Cisco Systems AIRCAP1552EUAK9 manual Installing a New Backup Battery, 3 Backup Battery Screws

Chapter 4 Installing or Replacing the Backup Battery

Installing a New Backup Battery

Step 3 Use a Phillips screw driver to remove the four screws attaching the backup battery to the cover (see Figure 4-3).

Figure 4-3 Backup Battery Screws

1	Battery backup screws (4 places)	3	Backup battery
2	Battery backup cable and connector	4	Access point radio cover

Installing a New Backup Battery

Note The AIR-1520-BATT-6AH= backup battery is used only on access point models AIR-CAP1552E-x-K9 and AIR-CAP1552EU-x-K9. Do not use this battery on model AIR-CAP1552H-x-K9, AIR-CAP1552SA-x-K9, or AIR-CAP1552SD-x-K9.

To install a new backup battery into your access point, follow these steps:

Step 1 Carefully orient your new backup battery as shown in Figure 4-3over the access point radio cover. Step 2 Position the backup battery over the four screw holes in the radio cover.

Step 3 Use the four supplied screws to attach the backup battery to the radio cover and tighten to 5.5 to 6.5 in. lbs (0.62 to 0.73 Nm).

Step 4 Position and bend the backup battery cable as shown in Figure 4-3.

Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide

OL-24247-01 4-5