Installing the Slide Assemblies in the Rack
NOTE: If the slide assemblies were preinstalled by Dell, you may skip this section.
You must allow 6 U (10.5 inches) of vertical space for each PowerEdge 2400 system you install in the rack.
NOTE: The rails of the rack are marked by small indentations in
1 unit (1.75 inches) |
Figure 1-6. One Rack Unit
For more information, see the Dell Rack Advisor software available on the Dell Web site at http://www.dell.com.
WARNING: If you are installing more than one computer, install the slide assemblies so that the first computer is installed in the lowest available position in the rack.
To install the slide assemblies in the rack, perform the following steps:
1.Place the front of the template over the front of the front rack rails (see Figure
Position the bottom of the template in line with the desired bottom position of the computer chassis.
2.Mark the upper- and
3.Turn over the template and place the back of the template over the front side of the back rack rails in the same position as you placed it on the front rack rail.