Dell 260S owner manual Error Messages, General Failure

Error Messages Description

THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION DRIVE

Restart the computer. If the error appears again,contact Dell.

The file that you are trying to copy is too large to fit on the disk, or the disk is full. Try copying the file to a different disk or use a larger capacity disk.

A FILENAME CANNOT CONTAIN ANY OF	Do not use these characters in filenames.
THE FOLLOWING CHARACTERS: \ / : * ? " <
> -
GATE A20 FAILURE	A memory module may be loose. Reinstall
	the memory modules and, if necessary,
	replace them.
GENERAL FAILURE	The operating system is unable to carry
	out the command. The message is usually
	followed by specific information. For
	example, Printer out of paper. Take the
	appropriate action.
HARD-DISK DRIVE CONFIGURATION	The computer cannot identify the drive
ERROR	type. Shut down the computer, remove the
	hard drive, and boot the computer from a
	optical drive. Then, shut down the
	computer, reinstall the hard drive, and
	restart the computer. Run the Hard Disk
	Drive tests in the Dell Diagnostics.
HARD-DISK DRIVE CONTROLLER FAILURE	The hard drive does not respond to
0	commands from the computer. Shut down
	the computer, remove the hard drive, and
	boot the computer from a optical drive.
	Then, shut down the computer, reinstall
	the hard drive, and restart the computer. If
	the problem persists, try another drive.
	Run the Hard Disk Drive tests in the Dell
	Diagnostics.
HARD-DISK DRIVE FAILURE	The hard drive does not respond to
	commands from the computer. Shut down
	the computer, remove the hard drive, and

54