266 Configuring Switch Information
www.dell.com | support.dell.com
Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address
parameters as displayed in the
Static MAC Address Table
page.
The following is an example of the CLI commands.
Table 7-71. Static Address CLI Commands
CLI Command Description
bridge address
mac-address
[
permanent
|
delete-on-reset
|
delete-on-timeout
|
secure
] {
ethernet
interface
|
port-
channel
port-channel-number
}
Adds a static MAC-layer station source
address to the bridge table.
show bridge address-table
[
vlan
vlan
]
[
ethernet
interface
|
port-channel
port-
channel-number
]
Displays entries in the bridge-forwarding
database.
console(config-if)#bridge address 00:60:70:4C:73:FF permanent
ethernet g8
console# show bridge address-table
Aging time is 300 sec
vlan mac address port type
---- ------------ ---- --------
100:60:70:4C:73:FF 1/e8 dynamic
1
00:60:70:8C:73:FF
1/e8
dynamic
200
00:10:0D:48:37:FF
1/e9