Panasonic PT-D12000 operating instructions Installation in a downward vertical position

PT-D12000/PT-DZ12000 Operating Instructions

Additions and Corrections to the Operating Instructions

■Installation in a downward vertical position

When installing the projector in a downward vertical position, please ensure to attach the supplied fittings to all lamp units. Without the fittings, the lamp life may be shortened.

When installing the projector other than in a downward vertical position, remove the fittings.

1. Range of the downward vertical position

Downward vertical position range: 45° forward and backward from the position perpendicular to the ceiling.

45°

45°

2. How to attach the fitting to the lamp unit

ARemove the lamp unit from the projector, following the “Procedure of lamp unit replacement” (Page 115) of the Operating Instructions.

BInsert the fitting into the gap between the plastic holder and the wire mesh as shown in the figure below.

∗Leave no gap between the fitting and the wire mesh.

Fitting

Plastic holder

Insert fitting between plastic holder and wire mesh.

CInstall the lamp unit into the projector, following the “Procedure of lamp unit replacement” (Page 115) of the Operating Instructions.

■Changes in the table in page 21 of the Operating Instructions

	Keystone correction only		When using arc and keystone correction together					Arc correction only
Lens	Vertical	Horizontal	Vertical	Horizontal	R2/L2	R3/L3	R2/L2		R3/L3 minimum value
	Keystone	Keystone	Keystone	Keystone
	Correction	Correction	Correction	Correction	minimum	minimum	minimum
	Angle α(°)	Angle β(°)	Angle α(°)	Angle β(°)	value	value	value		D12000		DZ12000
ET-D75LE1	±40	±15	±5	±5	1.6	3.2	0.8			1.6
ET-D75LE2	±40	±15	±5	±5	1.2	2.4	0.6			1.2
ET-D75LE3	±40	±15	±10	±10	0.8	1.6	0.4			0.8
ET-D75LE4	±40	±15	±10	±15	0.6	1.0	0.3			0.5
ET-D75LE5	±22	±15	±5	±5	3.0	6.0	1.5		3.0		4.3 ∗
ET-D75LE6	±28	±10	±5	±5	2.4	4.8	1.2		2.4		2.6 ∗
ET-D75LE8	±40	±15	±10	±15	0.4	0.8	0.2			0.4

∗ For DZ12000, the above value changes apply.

P0908-0A