1
2
tabs (2)
hard drive
Installing a Hard Drive
1.Unpack the replacement hard drive, and prepare it for installation.
2.Check the documentation for the drive to verify that it is configured for your computer.
3.If your replacement hard drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket rails to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each rail).
1drive
2bracket rails (2)
3screws (4)
4.Gently slide the drive into place until the tabs securely click into position.
NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
5.Connect the power and
