Dell 350 manual Removing the Chassis Intrusion Switch, Replacing the Chassis Intrusion Switch

Back to Contents Page

Chassis Intrusion Switch

Dell Precision™ Workstation 350 Service Manual

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.

Removing the Chassis Intrusion Switch

1.Disconnect the chassis intrusion switch cable connector from the control panel on the front of the chassis.

Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in place inside the chassis.

2.Slide the chassis intrusion switch out of its slot and remove the switch and its attached cable from the chassis.

Replacing the Chassis Intrusion Switch

To replace the chassis intrusion switch, follow the "Chassis Intrusion Switch" procedures in reverse order.

Resetting the Chassis Intrusion Detector

1.Enter system setup by pressing <F2> during the computer's POST.

NOTE: For instructions on using system setup, see the User's Guide.

2.Under the System Security tab, reset the Chassis Intrusion option by pressing the left- or right-arrow key to select Reset. Change the setting to Enabled, Enabled-Silent, or Disabled.

NOTE: The default is Enabled-Silent.

NOTE: If a setup password has been assigned by someone else, contact the network administrator for information on resetting the chassis intrusion detector.

3.Press <Alt><b> to restart the computer and implement your changes.

Back to Contents Page