Dell 4220 manual back door stabilizer bar bottom, plunger 2 per bar

Removing and Installing the Back Door Stabilizer Bars

The top and bottom bars used to stabilize the back doors can be removed, making it easier to route cables through the top and bottom of the rack.

1Open the back doors.

2Pull and hold the plungers on each side of the bar, and pull the bar up and away from the rack (see Figure 1-17).

3After routing your cables, replace the bars by aligning the tabs on the bars with the corresponding holes in the rack and pushing in and down until the plungers lock into place.

Figure 1-17. Removing and Installing the Back Door Stabilizer Bars

1

2

3

1	back door stabilizer bar (top)	2	plunger (2 per bar)
3	back door stabilizer bar (bottom)

Installation Guide

31