Beep Codes
Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. This series of beeps, called a beep code, identifies
a problem. One possible beep code (code 1-3-1) consists of one beep, a burst of three beeps, and then one beep. This beep code tells you that the computer
encountered a memory problem.
Reseating the memory modules may fix the beep code errors in the following table. If the problem persists, see "Contacting Dell" in your Owner's Manual for
instructions on obtaining technical assistance.
If you hear one of the following beep codes, see "Contacting Dell" in your Owner's Manual for instructions on obtaining technical assistance.
reinstall one memory module (if the computer supports a single module), and then
restart the computer. If the computer starts normally, move the memory module to a
different connector and restart the computer. Continue until you have identified a
faulty connector or reinstalled all modules without error.
Memory modules are
detected, but a memory
configuration or
compatibility error exists.
lEnsure that there are no special memory module/memory connector placement
requirements.
lVerify that the memory modules that you are installing are compatible with your
computer.
lIf the problem persists, contact Dell. See "Contacting Dell" in your Owner's Manual for
technical assistance.
Other failure has
occurred.
lEnsure that the cables are properly connected from the hard drive, CD drive, and DVD
drive to the system board.
lIf the problem persists, contact Dell. See "Contacting Dell" in your Owner's Manual for
technical assistance.
The computer is in a
normal operating condition
after POST.
None.
Code
Cause
1-3-1 through 2-4-4
Memory not being properly identified or used
4-3-1
Memory failure above address 0FFFFh
Code
1-1-2
1-1-3
1-1-4
1-2-1
1-2-2
1-2-3
3-1-1
3-1-2
3-1-3
3-1-4
3-2-2
3-2-4
3-3-1
3-3-2
3-3-4
3-4-1
3-4-2