Using Your Projector 43
WIRELESS AND NETWORK—Select On to activate wireless and network function. Press
to configure the Wireless and Network settings.
WIRELESS AND NETWORK
The Wireless and Network menu allows you to configure the network connection
settings.
DHCP—If a DHCP server exists in the network to which the projector is
connected, the IP address will automatically be acquired when you select DHCP
On. If DHCP is Off, manually set the IP Address, Subnet Mask, and Gateway. Use
to select the number of IP Address, Subnet Mask, and Gateway. Key in
Enter to confirm each number and then use to set the next item.
IP ADDRESS—Automatically or manually assigns the IP address to the projector
connected to the network.
SUBNET MASK—Configure the Subnet Mask of the network connection.
GATEWAY—Check the Gateway address with your network/system administrator if
you configure it manually.
DNS—Check the DNS Server IP address with your network/system administrator
if you configure it manually.
STORE—Press to save the changes made in network configuration settings.
WIRELESS—Default is Connect. Select Disconnect to disable the wireless
connection to use LAN networking only.
NOTE: It is recommended to use the default settings for Wireles s Connect.
RESET—Press to reset network configuration.