![](/images/new-backgrounds/1300315/30031527x1.webp)
•The notch in the top of the card or filler bracket fits around the alignment guide.
12.Close the card retention door by snapping it into place to secure the card(s).
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment.
13.Connect any cables that should be attached to the card.
See the documentation that came with the card for information about the card cable connections.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
14.Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
15.Install any drivers required for the card as described in the card documentation.
Removing a PCI Express Card
1.Follow the procedures in "Before You Begin."
2.Remove the computer cover.
3.If necessary, disconnect any cables connected to the card.
4.Pull back the securing tab, grasp the card by its top corners, and then ease it out of its connector.
5.If you are removing the card permanently, install a filler bracket in the empty
If you need a filler bracket, contact Dell.
NOTE: Installing filler brackets over empty
6. Secure the card(s) in the computer.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
7.Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
8.Remove the card driver from the operating system.