
Deploying the Dell PowerConnect 8100 with the Cisco Catalyst
Recommended Spanning Tree method: Portfast
Figure 7.
Dell PowerConnect 8100 CLI
No changes are required to the Dell PowerConnect 8100 for using this method.
Cisco Catalyst CLI
Run the commands below to enable portfast on all interfaces that are connected to the Dell PowerConnect 8100s.
cat6504E_1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
cat6504E_1(config)#interface tengigabitethernet 2/5
Review the bridge priority configurations on each switch to make sure the root bridge of the spanning tree is properly placed. Adjust the root bridge priorities higher or lower to place the root bridge within the Cisco environment.
For Dell, use the command
console(config)#spanning-tree priority xxxxx
On the Cisco Catalyst the commands that can be used are
or
15