Dell 8100 manual Vlan configuration example

Deploying the Dell PowerConnect 8100 with the Cisco Catalyst

VLAN configuration example

The following topology overview is an example of a much abbreviated network configuration between two (2) end-user systems, the campus switch, and the core.

Example of access, and trunk VLANs

Figure 6.

Dell PowerConnect 8100 CLI

Run the commands below on the Dell PowerConnect 8100 switch to create an access mode switchport going to a client (or edge) device. Then create a 2-port LACP LAG with a trunk mode switchport carrying VLANs between it and the Cisco Catalyst 6504.

console#configure console(config)#vlan 100, 101 console(config-vlan)#exit console(config)#interface te1/0/1

console(config-if-Te1/0/1)#switchport access vlan 100 console(config-if-Te1/0/1)#exitconsole(config)#interface te1/0/2 console(config-if-Te1/0/1)#switchport access vlan 101 console(config-if-Te1/0/1)#exit

9