16.To determine the version of the Bluetooth stack installed on your handheld device, locate the Bluetooth icon and tap it with the stylus to open the application. Find the Bluetooth About tab and tap to open the associated page. There you will find the version and build for the installed Bluetooth stack.

17.If more than one Bluetooth stack is found on the Pocket PC device when Setup is tapped, the keyboard application will display a Stack Selection dialog box. If the device has a built-in Bluetooth system, that stack should be used (e.g. Widcomm BTW-CE). If the device is using a removable Bluetooth card such as an SDIO card, a different stack may need to be used (e.g. Socket or Microsoft). If the wrong stack is selected a connection may not be possible. In such a case

return to the Stack Selection dialog box by tapping Enable on the Config page, then select Axim™ Wireless keyboard and tap Setup.

18.If the keyboard driver fails to detect any supported Bluetooth stack during the initial setup or at a later time (e.g. after power on), it will display the Bluetooth system not detected message on the BT page. This should not happen on Pocket PC devices with a built-in Widcomm stack version

≥1.4.x, since it is always present and is supported by the keyboard software. However, if the device has been upgraded with an incompatible version of the stack, then this message may be displayed or the software may function improperly. In such a case the keyboard software must be replaced with an updated version.

Axim™ Wireless Keyboard Owner’s Manual

Page 9