14 Using Your Projector
3
Using Your Projector

Turning Your Projector On

NOTE: Turn on the projector before you turn on the source (computer, DVD
player, etc.). The Power button light blinks blue until pressed.
1Remove the lens cap.
2Connect the power cord and appropriate signal cables. For information about
connecting the projector, see "Connecting Your Projector" on page8.
3Press the Power button (see "Using the Control Panel" on page 18 to locate the
Power button).
4Turn on your source (computer, DVD player, etc.)
5Connect your source to the projector using the appropriate cable. See
"Connecting Your Projector" on page8 for instructions to connect your source
to the projector.
6By default, the input source of projector is set to VGA-In. Change the input
source of projector if necessary.
7If you have multiple sources connected to the projector, press the Source
button on the remote control or control panel to select the desired source. See
"Using the Control Panel" on page18 and "Using the Remote Control" on
page21 to locate the Source button.

Turning Your Projector Off

NOTICE: Unplug the projector after properly shutting down as explained in the
following procedure.
1Press the Power button.
NOTE: The "Press Power Button to Turn off Projector" message will
appear on the screen. The message disappears after 5 seconds or you can
press the Menu button to clear it.
2Press the Power button again. The cooling fans continue to operate for 120
seconds.