Back to Contents Page
Internal Card With Bluetooth®Wireless Technology

Dell™Latitude™D530ServiceManual

Adding the Card
Removing the Card

Adding the Card

1. Follow the procedures in Before You Begin.
2. Remove the hard drive (see Hard Drive).
3. Attach the card cable to the wireless card.
4. Slide the card into the computer.
5. Attach the card cable connector to the system board as shown in the figure above.

Removing the Card

If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.
1. Follow the procedures in Before You Begin.
2. Remove the hard drive (see Hard Drive).
3. Pull the card cable connector out of the system board connector.
4. Pull the cable to remove the card from the computer.
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching a connector on the back panel of the
computer.
1
system board connector
2
card
3
cable connector
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.