8. Lift the management riser card away from the blade system board.
Figure 21. Removing and Installing the Management Riser Card
1. management riser card 2. screws (3)
3. system configuration jumpers 4. management riser card connector
Installing The Management Riser Card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Install the management riser card on the blade system board:
a. Lower the management riser card into place until the card connector fits into the corresponding
connector on the blade system board.
b. Secure the management riser card to the blade system board with the three screws.
2. Install the blade system board.
3. Replace the mezzanine card.
4. Reinstall the SSD backplane.
5. Replace the SSD(s).
If there are two SSDs, be sure to reinstall them in their original locations.
6. Install the SD card and the vFlash card.
7. Install the blade in the sleeve.
Replacing The SD Card
NOTE: The SD card in the lower card slot is the primary card (labeled as SD1) and the SD card in the
upper card slot is the secondary card (labeled as vFlash/SD2).
1. Enter the System Setup and ensure that the Internal SD Card Port is enabled.
52