Table 4. System Board Connectors
Item Connector Description
1 CPU2 Processor socket 2
2 A1, A2, A3 Memory module sockets (for processor 1)
3 MEZZ Mezzanine card connector
4 - Blade connector to the sleeve interposer card
5 J_LOM_RISER LOM riser card connector
6 CPU1 Processor socket 1
7 BAT1 Connector for the 3.0 V coin cell battery
8 B1, B2, B3 Memory module sockets (for processor 2)
9 J_PERC Management riser card connector
10 USB2 USB connector
11 USB1 USB connector
Disabling A Forgotten Password
The blade's software security features include a system password and a setup password. The password
jumper enables these password features or disables them, and clears any password(s) currently in use.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Remove the blade from the sleeve.
2. Remove the blade system board to gain access to the jumpers.
3. Relocate the jumper plug to disable the password feature.
4. Reinstall the blade system board.
5. Install the blade in the sleeve.
When the blade is on, the power-on indicator is solid green. Allow the blade to finish booting.
The existing passwords are not disabled (erased) until the system boots with the password removed.
However, before you assign a new system and/or setup password, you must reinstall the password
jumper.
NOTE: If you assign a new system and/or setup password with the jumper removed, the system
disables the new password(s) the next time it boots.
6. Remove the blade from the sleeve.
7. Remove the blade system board to gain access to the jumpers.
8. Relocate the jumper plug to enable the password feature.
9. Reinstall the blade system board.
10. Install the blade in the sleeve.
11. Assign a new system and/or setup password.
62