Figure 17. Removing and Installing the Blade System Board
1. blade release handle 2. blade system board
3. blade chassis
Installing The Blade System Board
1. Transfer the following components to the new blade system board:
a. Memory modules and memory module blanks.
b. Processor(s) and heat sink(s), or processor/DIMM blank.
c. LOM riser card
2. Slide the new blade system board into the open end of the blade chassis until the blade release latch
engages.
NOTE: Ensure that the system board is parallel with the chassis.
3. Replace the mezzanine card.
4. Reinstall the SSD backplane.
5. Replace the SSD(s).
If there are two drives, be sure to reinstall them in their original locations.
6. Install the SD card(s).
7. Install the blade in the sleeve.
8. Import your new or existing iDRAC Enterprise license. For more information, see the iDRAC7 User's
Guide at support.dell.com/manuals.
43