Dell S6000-ON - page 231

CAM Allocation Setting
vrfv4Acl 0
Openflow 0
fedgovacl 0
NOTE: When you reconfigure CAM allocation, use the nlbclusteracl number command to change
the number of NLB ARP entries. The range is from 0 to 2. The default value is 0. At the default value
of 0, eight NLB ARP entries are available for use. This platform supports upto 256 CAM entries.
Select 1 to configure 128 entries. Select 2 to configure 256 entries. Even though you can perform
CAM carving to allocate the maximum number of NLB entries, Dell Networking recommends you to
use a maximum of 64 NLB ARP entries.
The following additional CAM allocation settings are supported on the S6000, S4810, S4820T, or S6000–
ON platforms only.
Table 11. Additional Default CAM Allocation Settings (S6000, S4810, S4820T, and S6000–ON Only)
Additional CAM Allocation Setting
FCoE ACL (fcoeacl) 0
ISCSI Opt ACL (iscsioptacl) 0
You must enter the ipv6acl and vman-dual-qos allocations as a factor of 2 (2, 4, 6, 8, 10). All other
profile allocations can use either even or odd numbered ranges.
For the new settings to take effect, you must save the new CAM settings to the startup-config (write-
mem or copy run start) then reload the system.
CAM Allocation for Egress
To allocate the space for egress L2, IPV4, and IPV6 ACL, use the cam-acl-egress command. The total
number of available FP blocks is 4. Allocate at least one group of L2ACL and IPV4 ACL.
Dell(conf)#do show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
-- Stack unit 7 --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
Dell(conf)#
1. Select a cam-acl action.
Content Addressable Memory (CAM) 231