CLI Command Mode Prompt Access Command
LLDP MANAGEMENT INTERFACE Dell(conf-lldp-mgmtIf)# management-interface (LLDP
Mode)
LINE Dell(config-line-console)
or Dell(config-line-vty)
line console orline vty
MONITOR SESSION Dell(conf-mon-sess-
sessionID)#
monitor session
OPENFLOW INSTANCE Dell(conf-of-instance-of-
id)#
openflow of-instance
PORT-CHANNEL FAILOVER-
GROUP
Dell(conf-po-failover-
grp)#
port-channel failover-
group
PRIORITY GROUP Dell(conf-pg)# priority-group
PROTOCOL GVRP Dell(config-gvrp)# protocol gvrp
QOS POLICY Dell(conf-qos-policy-out-
ets)#
qos-policy-output
VLT DOMAIN Dell(conf-vlt-domain)# vlt domain
VRRP Dell(conf-if-interface-
type-slot/port-vrid-vrrp-
group-id)#
vrrp-group
UPLINK STATE GROUP Dell(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to
PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION,
INTERFACE, SPANNING TREE, and so on.) without having to return to EXEC mode by preceding the EXEC
mode command with the do command.
The following example shows the output of the do command.
Dell(conf)#do show system brief
Stack MAC : 34:17:eb:f2:c2:c4
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version
Ports
Configuration Fundamentals 41