Connecting the Monitor | Dell ST2220 specs

Connecting the Monitor

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.

To connect your monitor to the computer perform the following steps/instructions:

1.Turn off your computer and disconnect the power cable.

2.Connect the HDMI cable, white (digital DVI-D), or blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use all the cables on the same computer. Use all of the cables only when they are connected to different computers with appropriate video systems.

Connecting the blue VGA cable

Connecting the White DVI Cable*

Connecting the HDMI Cable* (for selective models)

NOTE: *Optional purchase item. To purchase DVI or HDMI cable, please visit Dell.com

NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.

After you have completed connecting the VGA/DVI/HDMI cable, follow the procedure below to complete your monitor setup:

1.Plug the power cables for your computer and monitor into a nearby outlet.

Image 28

Dell ST2220 appendix Connecting the Monitor

Contents

Dell ST2220L/ST2220M monitor Users Guide Package Contents About Your Monitor Product Features Identifying Parts and Features Front ViewBack View Front View Front Panel Controls Label Description Side View Bottom ViewBack View Label Description/Use Left Side Power Management Modes Monitor SpecificationsPin Assignments DVI Connector Pin Pin Side of the Connected Signal Number Cable Resolution Flat Panel SpecificationsModel ST2220L/ST2220M Preset Display Modes Physical CharacteristicsVideo Supported Modes Electrical Maintenance Guidelines EnvironmentalPlug and Play Capability LCD Monitor Quality & Pixel Policy Back to Contents Appendix Setting Up Your Monitor Click Change Display Settings Click Advanced Settings Using the On-Screen Display OSD Menu Using the Front PanelOperating the Monitor Main Menu for non Analog non VGA Input Brightness Contrast Back Auto Adjust Input Source Auto Select VGA DVI-D Display Settings Page DDC/CI Factory Reset Personalize OSD Warning Messages Using the Dell Soundbar Optional Setting the Maximum ResolutionClick Change Display Settings Using the Tilt Tilt Setting Up Your Monitor Dell ST2220L/ST2220M monitor Setting Up the Monitor Attaching the Base Connecting the Monitor Attaching the Soundbar Optional Removing the Monitor Stand Built-in Diagnostics Solving ProblemsSelf-Test Common Problems Common Symptoms What You Experience Possible Solutions Product-Specific Problems Troubleshooting the Dell Soundbar Optional Back to Contents