5.If applicable, remove the SD card(s).
6.Pull out the internal dual SD module from the system board.
7.Close the system.
8.If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
9.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 49. Removing and Installing the Internal Dual SD Module
1.SD card connector on system board
2.SD card slot 1
3.SD card slot 2
4.SD card
Installing An Internal Dual SD Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2.If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
3.Open the system.
4.Locate the internal dual SD module connector on the system board.
5.Align the connectors on the system board with the connectors on the internal dual SD module.
6.Press the internal dual SD module until it is seated on the system board.
7.Close the system.
8.If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
93
