DeLonghi DE608MLH, DE608MRH manual Replacing the Oven Lights, Left Lamp

REPLACING THE OVEN LIGHTS

WARNING: Ensure the appliance is switched off before replacing the lamp/s to avoid the possibility of electric shock.

■■ Let the oven cavity and the heating elements to cool down. ■■ Switch off the electrical supply.

LEFT LAMP

■■ Remove the left wire rack and the side catalytic panel by unscrewing the fixing screws (see chapter “USE AND CARE” at page 14).

■■ Press down from the top the protective cover “A” (fig. 18) and remove it by rotating on the lower side.

IMPORTANT: Never use screwdrivers or other utensils to remove the cover “A”.

This could damage the enamel of the oven or the lampholder. Operate only by hands.

■■ Replace the halogen lamp “B” with a new one suitable for high temperatures having the following specifications: 220-240V or 230-240V, 50 Hz and same power (check watt power as stamped in the bulb itself) of the replaced lamp.

IMPORTANT WARNING: Never replace the lamp with bare hands; contamination

from your fingers can cause premature failure. Always use a clean cloth or gloves. ■■ Refit the protective cover “A” operating in reverse order.

ATTENTION: The notch in the inner edge of the cover must be oriented toward the lamp. Assemble the side catalytic panel and the left wire rack.

TOP RIGHT LAMP:

■■ Remove the protective cover “C” (fig. 18).

■■ Replace the halogen lamp “B” with a new one suitable for high temperatures having the following specifica- tions: 220-240V or 230-240V, 50 Hz and same power (check watt power as stamped in the bulb itself) of the replaced lamp.

IMPORTANT WARNING: Never replace the lamp with bare hands; contamination from your fingers can cause premature failure. Always use a clean

cloth or gloves.

■■ Refit the protective cover “C”.

NOTE: Oven bulb replacement is not covered by your gua- rantee.

WRONG

CORRECT

1

A

2 A B A B C

Figure 18

29