DeLonghi DEF905E manual Connection Of The Power Supply Cable, Voltage And Power Consumption

CONNECTION OF THE POWER SUPPLY CABLE

Important! This cooker must be connected to the electricity supply only by an au- thorised person.

To connect the feeder cable to the cooker it is necessary to:

•Remove the two screws that hold shield “A” behind the cooker (fig. 12).

•Open completely the cable clamp “D”.

•Fitted with a 6-pole terminal block, position the U bolts onto terminal block ‘B’ (fig. 12) according to the diagrams in figs. 13 - 14.

•Feed the supply cable through the cable clamp “D”. The supply cable must be of a suitable size for the current requirements of the appliance; see the section “Feeder cable section”.

•Connect the phase, neutral and earth wires to terminal “B” according to figures 13 and 14.

•Pull the feeder cable and block it with the cable clamp “D”.

•Re-mount shield “A”.

N.B. The earth conductor must be left about 3 cm longer than the others.

VOLTAGE AND POWER CONSUMPTION

230/400 V 3N~	50 Hz	11800 W (51.30 A) (diversity not applied)
240/415 V 3N~	50 Hz	12800 W (53.33 A) (diversity not applied)

FEEDER CABLE SECTION

This cooker must be connected to electrical supply using V105 insulated cable.

230	V~, 240 V~		3 x 6 mm2	(*)
230	V 3~, 240 V~		4 x 4 mm2	(*)
400	V 3N~,	415 V 3N~	5 x 2,5 mm2 (*)
400 V 2N~,		415 V 2N~	4 x 4 mm2	(*)
(*	Connection with wall box connection.

––Diversity factor applied.

––A diversity factor may be applied to the total loading of the appliance only by a suitably qualified person.

12