LIGHTING THE BURNERS (fitted with safety cut-off valve)
In order to light the burner, you must:
1 – Turn the knob fig. 12 in 
), push in and hold the knob; this will light the gas.
2 – Wait for about ten seconds after the gas burner has been lit before letting go of the knob (valve activation delay).
3 – Adjust the gas valve to the desired position.
Important
■If the burner flame should go out, the safety valve will automatically stop the gas flow.
■To 
position, wait for at least 1 minute and then repeat the lighting procedure.
■N.B. If your local gas supply makes it difficult to light the burner with the knob set to maximum, set the knob to minimum and repeat the operation.
18
